Designed and install in a temperature critical explosion proof environment. This job included explosion proof exhaust fans as well as 2 800 000 BTU custom makeup air units
Stainless Steel piping run feeding industrial paint spray booth
Direct fired 2.5 MBTU header. Scott Refrigeration's Gas Technician 1 license holders can look after any and all of your natural gas or propane equipment
The louvers and frames replaced the original undersized ones. The frames were custom fabricated to fit into the original openings without any disruption to the exterior face of the building. They were all lifted into place and welded into the existing frames.
All line sizing calculations and component selection were completed by Scott Refrigeration. Installation and system commissioning completed and documented.
Custom duct work manufactured and installed for an industrial spray booth.
3- 399 000 BTU IBC Condensing Boiler line up installed to feed multiple in-floor zones, supplementary air handlers, and domestic hot water recirc lines as well as storage. 1 command boiler and 2 slaves operating under 1 system for maximum efficiency and savings for this customer. Shown with IBC's Multiplex Racking system
Custom designed low intensity infrared heater installation. This project was to designed and engineered to fulfill our customer's requirements. Material stored outdoors enters the area and is required to be 100% dry and brought to design temperature within 20 minutes. This project was completed with a custom control panel, multi level staging and monitoring station.
Retrofit boiler installation. New IBC boilers. Serving domestic hot water, in-floor multi loops, as well as supplementary heat with ground source heat pump system. New systems complete with DURA Vent system operates at 97.7% efficiency