CONTACT US BY EMAIL FOR A SCHEDULED CALL. WE ARE A GROUP OF COMPANIES THAT PROVIDE A COMPLETE SUPPORT SYSTEM FROM DESIGN INTEGRATION TO MATERIALS SUPPLY AND SITE RELATED SERVICES. WE WILL SEND YOU ADDITIONAL INFORMATION IN ADVANCE OF OUR CALL. NOTE: WE ARE GROWING RAPIDLY AND WILL BE BRINGING FULL 3D INTEGRATION ON LINE BY MID YEAR.
LSO CROSS-SECTIONS AND DESCRIPTIONS
IMPORTANT: FOR ALL FORCED AIR HVAC SYSTEMS- The secondary duct path to any manufacturers supply outlet or our LSO Design Components described here must allow a straight secondary duct path for at least 12"-15" before the connection to these fenestrative components for optimum airflow and quiet operation. As a designer, it is hard not to minimize utility spaces BUT PLEASE give the equipment the room it needs to perform properly.
LSO Design offers our design components below in "Standard" (STD) and "High Performance" (HP) versions. The "Standard Components" dimensions shown here are general but are sized to fit common framing conditions.
The component uses suggested below are very flexible to meet your needs.
Example- In a hallway or bath requiring a "Ceiling Mounted" component you may use an "R" Series or "S" Series component to achieve straight down airflow, if the framing condition allows, instead of the "C" Series or Ceiling Components designed to direct the airflow away from exterior glass surfaces.
The "High Performance" or "HP" components are for application during the development of your design where the number of duct runs is critical or in markets where the installing contractors modify the manufacturer's standard installation and operating instructions. We recommend that the equipment manufacturer's standards be strictly followed. The "High Performance" or "HP" components vary in overall dimensions by 1/2" to 1" in height and width of the cross-section.
All information shown on this page is for "Standard Components".